#Aeon labs z stick remove update#

Press the button on the back of the sensor and the firmware update should proceed. Then, when you hit the update button in the Aeon firmware update tool, the update tool will tell you that it is waiting for the sensor to wake up. You may also need to associate the sensor to the Z-Stick (I canвЂ™t remember at the moment): The code for the SmartThings device handler would be (replace nodeid with the id of your Z-Stick - in hex): If it was joined while battery powered, you need to temporarily set the sensor to send its wake report to the Z-Stick. If it was joined while USB powered, then you just find the node in the upgrade app provided by Aeon and click the update button. Looks like this:ДЄt this point, updating the Multi Sensor 6 is a little different depending on how it was joined to the network. After the Z-Stick is a secondary controller, you will have to request updates from the SmartThings hub whenever you add a device to your network from the hub (as mentioned). You need to put the SmartThings hub into inclusion mode and then with the Z-Stick and Zensys Tools put the Z-Stick into Learning mode. Also, the method the previous poster described doesnвЂ™t have to do with bringing in a device from a different network, as you are and a few other members have been using zsticks with their SmartThings hub as primary, hopefully they will have more to add.

Z wave devices are given an ID by the hub.

That method only works with zigbee devices like the lightbulb described because a zigbee device has its own unique ID that it tells the hub at the time of pairing. (Note that the previous posterвЂ™s comment about virtual devices does not apply to Z wave devices.

SmartThings is intended as a multi protocol platform, and for that reason it doesnвЂ™t use controller replication and a few of the other advanced Z wave features.ДЇortunately, the zstick does have the option to request network updates, which does allow you to do a little more. ItвЂ™s technically possible to add a secondary controller like the Z stick to smartthings, but it doesnвЂ™t always work very well.

Aeon labs z-stick remove